Results 1 to 2 of 2

Thread: Dunnage Done

  1. #1

    Dunnage Done

    A quick, reliable, cheap & safer method of fitting dunnage into a freight container is illustrated below.
    It was necessary to show the cardboard sheets as transparent to expose the method.
    Why here? No dunnage - lower level.
    Attached Images Attached Images
    John Gateley
    johngateley@hotmail.com
    www.the-credible-bulk.com

  2. #2

    Talking More of the Same

    In a previous post I indicated an improved closure method for restraining particulates within a freight container. To finally, hopefully, quantify the cargo behaviour it is necessary to consider the effects of full intermodal activity. Ships will undoubtedly present constant motions which might eventually flatten the container contents. Accepting that worst case scenario simplifies the calculation of the dunnage required to maintain effective sealing of the contents against spillage when opening the doors.
    There are 2 sizes for standard containers, 20 ft & 40 ft. Imperial units are chosen by design. Containers originated in 1930’s Britain where the standard was 30 ft & pounds feet prevailed throughout the Empire. Despite the 20 & 40 ft names normal engineering MKS units apply. Respective floor areas are 14.134 & 28.621 m2 & payloads are 28.32 & 26.73 tonnes therefore maximum heights to be restrained for material with SG=1.0 are 2.00 & 0.93m. So coal can never fill a 20 footer to capacity whereas cement will struggle to fill a 40 footer, obviously, but the commercial & practical limitations need to interact effectively. A correctly restrained load is not for debate when the dunnage is correctly placed. Conditions such as negative surcharge or sloping floor have been sensibly ignored. All available containment methods e.g. liners, plywood panels, sequentially opened doors or letterboxes will release some spillage.
    The closure method described earlier will minimise that spillage. Users are given freedom to decide the vertical pitch of planks according to their width & mindful of the customer’s acceptance of spillage release.

    Vertical pitch ≤ plank width x tangent (repose angle) for minimum spill
    &
    Vertical pitch ≤ plank width x tangent (surcharge angle) for minimum no spill

    Consignors should ensure that their loading regime complies with their consignees transport facilities regarding weight transfer during transit. Such effects are very small but police attitudes also differ.
    John Gateley
    johngateley@hotmail.com
    www.the-credible-bulk.com

Similar Threads

  1. Screw Compressor Work Done
    By prash1820 in forum Pneumatic Conveying
    Replies: 8
    Last Post: 5th March 2015, 16:35
  2. Dunnage Machine
    By shaukat parkar in forum New Projects, Tenders, Inquiries
    Replies: 0
    Last Post: 29th May 2007, 7:55
  3. Dunnage Machine
    By shaukat parkar in forum Jobs & Vacancies
    Replies: 0
    Last Post: 29th May 2007, 7:38

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Single Sign On provided by vBSSO