Results 1 to 1 of 1

Thread: 'The Gully Angle of pyramid shaped Hoppers' by Lyn Bates

  1. 'The Gully Angle of pyramid shaped Hoppers' by Lyn Bates

    The Gully Angle of pyramid shaped Hoppers
    by Lyn Bates, AJAX Equipment Co., U.K.

    Rectangular hoppers are widely used to store bulk solids. Although convenient to fabricate they have process drawbacks in that large flat sides are prone to deflection, so often require stiffening, and the converging faces form gully angles that offer poor flow and self-clearing properties. Some small compensation is given by the rectangular outlets being somewhat easier to fit with slide valves. ​​

    The gully angle of a symmetrical, pyramid shaped hopper is roughly 10 degrees less steep than sides and is prone to retention of product unless radiused.

    For Mass Flow design purposes, the inclination of the gullies should be considered as a cone.

    For Funnel Flow hoppers the gully angle should exceed the wall friction angle by at least 50. Some product retention in the corners is almost inevitable unless the corner is radiused or significantly increased in inclination.

    (Mass flow is much more practical and residue much less likely if the end walls are made vertical).

    The ratio of length to width of an outlet must exceed 3:1 to secure the full flow benefits of a slot outlet and provide reliable discharge similar to a circular outlet diameter that is twice the slot width.

    Two opposing walls must be longer than the ‘critical rathole diameter’ and sufficiently steep to permit mass flow to ensure that the hopper will not ‘rathole’. The ends must still be considered as parts of a cone to guarantee mass flow, otherwise the end sections will only self-clear according to the ‘settled density, drained repose’ angle.

    Where Ө1 and Ө2 are the inclination of the two sides of the hopper.

    © 2019 by Lyn Bates, U.K.

    Last edited by drottboommarcel; 31st January 2019 at 9:37.

Similar Threads

  1. Forum: Solid Sense by Lyn Bates
    By Author in forum bulk-online Forums Surveys
    Replies: 0
    Last Post: 7th October 2012, 16:44
  2. Discussion on "Solid Sense" by Lyn Bates
    By Author in forum Ask Lyn Forum
    Replies: 1
    Last Post: 28th January 2012, 11:09
  3. Solid Sense by Lyn Bates - Contents
    By Lyn Bates in forum Solid Sense by Lyn Bates
    Replies: 0
    Last Post: 26th January 2012, 17:45
  4. Lyn Bates: bsh 7/2006
    By designer in forum Publications, Standards, Patents, Catalogs
    Replies: 0
    Last Post: 22nd December 2006, 14:24
  5. Award for Lyn Bates
    By Author in forum People & Positions
    Replies: 0
    Last Post: 2nd August 2004, 12:35

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Single Sign On provided by vBSSO