Results 1 to 6 of 6

Thread: The Economical Reclaimer for Longitudinal Stockyard

  1. #1
    Bob Chen

    Bob Chen

    General Manager

    Yangzhou FusionBMH Engineering Co.,Ltd

    Yangzhou FusionBMH Engineering Co.,Ltd

    Professional Experience 10 Years / 0 Month Bob Chen has 10 Years and 0 Month professional experience

    Discussions 9 Bob Chen acceded to 9 discussions, Publications 0 Bob Chen Chen released 0 publications

    Know-How Reclaimer (21) Bob Chen used this tag 21 times, Material (16) Bob Chen used this tag 16 times, Stacker (16) Bob Chen used this tag 16 times

    The Economical Reclaimer for Longitudinal Stockyard

    The portal reclaimer is an economical solution for material reclaiming in longitudinal stockyard.
    Portal Reclaimer 1.jpg
    Portal Reclaimer 2.jpg


    Bob Chen
    General Manager
    Yangzhou FusionBMH Engineering Co.,Ltd
    Jiangyang Industrial Zone,Yangzhou
    225000 China
    Mobile:+86-15105252769
    E-mail: sinomayz@gmail.com
    fusionbmh@gmail.com
    Website: www.fusionbmh.com

  2. #2

    Brave New World

    The luffing rope is not shown. This is a shame because it would be interesting to see how the booms stretch.
    Also there is a ladder on the auxiliary boom which has no handrail & doesn't seem to be going anywhere important.

    I would suggest that you finish a drawing before you check it. You haven't done either. But then again it is BMH!
    John Gateley
    johngateley@hotmail.com
    www.the-credible-bulk.com

  3. #3
    Bob Chen

    Bob Chen

    General Manager

    Yangzhou FusionBMH Engineering Co.,Ltd

    Yangzhou FusionBMH Engineering Co.,Ltd

    Professional Experience 10 Years / 0 Month Bob Chen has 10 Years and 0 Month professional experience

    Discussions 9 Bob Chen acceded to 9 discussions, Publications 0 Bob Chen Chen released 0 publications

    Know-How Reclaimer (21) Bob Chen used this tag 21 times, Material (16) Bob Chen used this tag 16 times, Stacker (16) Bob Chen used this tag 16 times

    Thanks

    Thank you for your comments.

  4. #4
    Bob Chen

    Bob Chen

    General Manager

    Yangzhou FusionBMH Engineering Co.,Ltd

    Yangzhou FusionBMH Engineering Co.,Ltd

    Professional Experience 10 Years / 0 Month Bob Chen has 10 Years and 0 Month professional experience

    Discussions 9 Bob Chen acceded to 9 discussions, Publications 0 Bob Chen Chen released 0 publications

    Know-How Reclaimer (21) Bob Chen used this tag 21 times, Material (16) Bob Chen used this tag 16 times, Stacker (16) Bob Chen used this tag 16 times

    Thanks

    Dear Mr Gateley

    On the auxiliary boom there is no ladder. The structure is a guide rail. On the end of of the auxiliary
    boom there are wheels which will run on the guide rail.

    Bob Chen
    General Manager
    Yangzhou FusionBMH Engineering Co.,Ltd
    Jiangyang Industrial Zone,Yangzhou
    225000 China
    Mobile:+86-15105252769
    E-mail: sinomayz@gmail.com
    fusionbmh@gmail.com
    Website: www.fusionbmh.com

  5. #5

    A Stan Walker Special.

    Both booms are pinned together. They are also pinned against the portals. When you lift the inner pin you shove the outer pins apart & pull them in later.
    Do you have a secret weapon?
    John Gateley
    johngateley@hotmail.com
    www.the-credible-bulk.com

  6. Hello,

    Some time, particular material can be reclaimed by bucket wheel reclaimer (bucket wheel on boom or bridge) or by scraper reclaimer machine. The machine buyer can opt for anyone type considering following aspects:

    1) Required degree of homogenisation (blending), if applicable.

    2) Capacity range for each type, and in this context whether one has freedom to choose anyone.

    3) Initial cost (mechanical, structural, civil)

    4) Operation cost (wear, tear, repair, etc.)

    Buyer can opt for any one type considering economy (if both types are suitable for particular material). The economy should also take into consideration the machine life.

    The general beliefs are:
    - Bucket wheel on bridge or boom is heavier and sturdier machine. Its capacity range is likely to be more.

    - Scraper reclaimer machine will have better blending as it is simultaneously reclaiming along line (boom length) as against point reclaiming by bucket wheel.

    - One can obtain quotation for both types and opt for machine which is economical and suitable.

    Ishwar G. Mulani
    Author of Book: ‘Engineering Science And Application Design For Belt Conveyors’. Conveyor design basis is ISO (thereby book is helpful to design conveyors as per national standards of most of the countries across world). New print Nov., 2012.
    Author of Book: ‘Belt Feeder Design And Hopper Bin Silo’
    Advisor / Consultant for Bulk Material Handling
    System & Issues.
    Pune, India. Tel.: 0091 (0)20 25871916
    Email: conveyor.ishwar.mulani@gmail.com
    Website: www.conveyor.ishwarmulani.com

Similar Threads

  1. FAIRO Stockyard Vehicles for Maximum Storage Capacity on Stockyard Site (J. Gateley)
    By drottboommarcel in forum bulk solids handling - Vol. 16 (1996) No. 4
    Replies: 0
    Last Post: 16th September 2018, 19:56
  2. Conveying Velocity in Longitudinal Tensioning Meshes
    By diego.peinado in forum Screening & Feeding
    Replies: 3
    Last Post: 21st October 2006, 4:24
  3. Longitudinal Crack in Conveyor Belt
    By irfan in forum Trough Belt Conveying
    Replies: 12
    Last Post: 28th July 2006, 19:52
  4. Online Detection of Longitudinal Belt Cut
    By mahesh in forum Trough Belt Conveying
    Replies: 8
    Last Post: 16th May 2005, 23:06
  5. Longitudinal Cracking at Trough Line
    By Dale Coward in forum Trough Belt Conveying
    Replies: 16
    Last Post: 24th December 2004, 2:34

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Single Sign On provided by vBSSO