Results 1 to 4 of 4

Thread: What Should We Pay Attention to in the Coal Sample Weighing Process?

  1. #1
    CKIC Chinq Guest

    Post What Should We Pay Attention to in the Coal Sample Weighing Process?

    What Should We Pay Attention to in the Coal Sample Weighing Process?

  2. #2

    Cool Time is Everyone's Enemy.

    Plant layout is very important. Coal is tested to various Standards and equipment suppliers meet those requirements quite admirably. There is an issue with siting the gear because the samples are, very reasonably, the last resort before the stuff goes into the bunkers or holds. Once it is there it is impossible to change the outcome except for the commercial implications. Final test results are usually only available once the ship is on the high seas or already burnt. Enter the contract engineers and accountants which means it is time for a tea break.
    Sample weighing cannot be a criteria unless the scales are not calibrated, as if.
    After all the rigmarole with coal sampling no one has devised a safe means of lowering the secondary sample, often more than 7 floors, to the lower level where it can be oven dried and stored. Tubs swing about in the wind and there is a possibility that samples get spilled. Make it safe in terms of cutter isolation and sample handling and leave the rest to the committees.
    John Gateley

  3. Questions arising

    Dear Sir,

    searching for CKIC on the net and finding an extensive website dedicated to coal sampling, we would consider you being placed in a very good position to know rather much about said topic.
    Could you kindly enlighten us as to something specifical being on your mind, or rather if you want to promote your company, you are welcome to do so after permission from the website's owner.
    Kind regards

  4. #4

    Angry Still Employed There??

    Roland is far more polite than I am going to be.

    If somebody who is asking about sample weighing is in fact a specialist in that very same subject then it is better not to show crass ignorance. Either that or admit that you had married into the firm in the first place. The owner must be very understanding because you have done great damage to his business by asking questions that he probably spent years answering.
    John Gateley

Similar Threads

  1. Sample Amount for Coal
    By kaushlesh in forum Sampling, Inspection & Statistics
    Replies: 6
    Last Post: 30th December 2009, 17:32
  2. Sample Transfer Conveyor
    By andrewb - Rio Tinto, Australia in forum Mechanical Conveying
    Replies: 6
    Last Post: 4th March 2009, 10:12
  3. Ceramics Sample Preparation
    By Author in forum Whitepapers / Technical Articles / Guidelines
    Replies: 0
    Last Post: 14th October 2008, 18:28
  4. Inline Sample Splitter
    By thony in forum Sampling, Inspection & Statistics
    Replies: 8
    Last Post: 13th February 2008, 18:13
  5. Compact sample splitter
    By ID&T in forum Sampling, Inspection & Statistics
    Replies: 2
    Last Post: 13th September 2002, 13:58

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Single Sign On provided by vBSSO